1.1This test method measures cut resistance of foot protective devices that are designed to protect the foot when operating a chainsaw.

1.2This test method may be used to test for compliance to minimum performance requirements in established safety standards.

1.2.1By agreement between the purchaser and the supplier, or as required by established safety standards, this test method can be used to determine any one or both of the following: (1) chain speed 50 (CS50), (2) success/failure (jamming/chain stop) at specified chain speed.

1.3This test method may be used to determine levels of protection for areas of coverage as stipulated in established safety standards.

1.4The values stated in SI units are to be regarded as standard.

Note 1:The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.