ASTM B680-80(2014)
Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution
ASTM International , 11/01/2014
1.1This test method covers a test for the quality of seal of porous anodic coatings on aluminum and its alloys. It is based upon the loss in mass of the coating after immersion in a warm phosphoric-chromic acid solution.
1.2This test method is applicable to anodic coatings intended for exposure to the weather, or for protective purposes in corrosive media, and where resistance to staining is important.
1.3This test method is not applicable to:
1.3.1Hard coatings, which normally are not sealed.
1.3.2Anodic coatings that have been sealed only in dichromate solutions.
1.3.3Anodic coatings that have undergone a treatment to render them hydrophobic.
1.4The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
