1.1The specification² covers plate, sheet, and strip of nickel-chromium-iron-molybdenum-copper alloys (UNS N06007, N06975, N06985, and N06030)* as shown in Table 1, for use in general corrosive service.

TABLE 1 Chemical Requirements

Element	Composition Limits, %
Element		Alloy N06007	Alloy N06975	Alloy N06985	Alloy N06030
Nickel		remainder^A	47.0 to 52.0	remainder^A	remainder^A
Chromium		21.0 to 23.5	23.0 to 26.0	21.0 to 23.5	28.0 to 31.5
Iron		18.0 to 21.0	remainder^A	18.0 to 21.0	13.0 to 17.0
Molybdenum		5.5 to 7.5	5.0 to 7.0	6.0 to 8.0	4.0 to 6.0
Copper		1.5 to 2.5	0.70 to 1.20	1.5 to 2.5	1.0 to 2.4
Manganese		1.0 to 2.0	1.0 max	1.0 max	1.5 max
Cobalt, max		2.5	...	5.0	5.0
Carbon, max		0.05	0.03	0.015	0.03
Tungsten		1.0 max	...	1.5 max	1.5 to 4.0
Silicon, max		1.0	1.0	1.0	0.8
Phosphorus, max		0.04	0.03	0.04	0.04
Sulfur, max		0.03	0.03	0.03	0.02
Columbium + tantalum		1.75 to 2.50	...	0.50 max	0.30 to 1.50
Titanium		...	0.70-1.50	...	...

^A The composition of the remainder element shall be determined arithmetically by difference.

1.2The following products are covered under this specification:

1.2.1Sheet and Strip-Hot or cold rolled, solution annealed, and descaled unless solution anneal is performed in an atmosphere yielding a bright finish.

1.2.2Plate-Hot or cold rolled, solution annealed, and descaled.

1.3The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.