1.1This practice describes a procedure for measuring the ductility of electrodeposited foils.²

1.2This practice is suitable only for the evaluation of electrodeposits having low ductility.

1.3The obtained ductility values must only be considered semi-quantitative because this test has a significant operator dependence.

1.4This practice is best used for in-house process control where measurements are always made by the same operator. A change in ductility value can be used as an indication of possible changes in the electroplating solution.

1.5The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6This standard does not purport to address the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.