ASTM G22-23
Standard Practice for Determining Resistance of Plastics to Bacteria
standard by ASTM International , 02/01/2023
$31.00
$61.00
1.1 This practice covers two procedures, A and B, for determining the effect of bacteria on the properties of plastics in the form of molded and fabricated articles, tubes, rods, sheets, and film materials. Procedure B provides a more extensive contact between the test bacteria and the specimens than does Procedure A. Changes in optical, mechanical, and electrical properties may be determined by the applicable ASTM methods.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Product Information
Published:
02/01/2023
Pages:
3
File Size:
1 file , 68 KB
Language:
English
Note:
This product is restricted and cannot be purchased in the following countries Russia, Ukraine, Belarus
